Prime HVAC Master technicians install every component with precision. Installation includes:

Outdoor Unit Installation:
Level, stable surface placement (concrete pad minimum 18 inches from ground)
Proper clearance: 24 inches minimum from walls, fences, and shrubs
Vibration isolation pads (reduce noise transmission)
Electrical disconnect within 10 feet of the unit

Indoor Unit Installation:
Wall-mounted or floor-mounted placement based on home layout
Minimum 12-inch clearance on all sides (allows proper airflow)
Insulated condensate drain line (prevents water damage)
Secure mounting brackets (prevent vibration noise)

Refrigerant Lines:
Copper tubing sized to system capacity
Insulation wrap on all refrigerant lines (prevents heat loss)
Proper slope toward condensate drain (minimum 1/4 inch per 10 feet)
Vibration isolation on line supports (reduces noise)

Electrical Connections:
240V dedicated circuit (most systems require 240V service)
Proper breaker sizing (40-60 amp breaker is typical for residential)
Ground fault circuit interrupter (GFCI) protection
All connections meet National Electrical Code (NEC) standards

Ductwork Integration:
Supply ductwork sized for system capacity (improper sizing reduces efficiency 10-20%)
Return ductwork sealed at all joints (prevents air leakage)
Proper duct insulation (R-6 minimum in unconditioned spaces)
Balanced airflow (supply and return equal in capacity)

Installation includes system evacuation (removes all air and moisture from refrigerant lines) and charge with the correct refrigerant amount (measured in pounds specific to system model).